54
• Accessible surfaces of the toaster may
get hot during use.
• NOTE: Any plug cut from power
supply cord should be disposed of
immediately. Inserting any cut off plug
into a 13A socket-outlet is hazardous.
• Never use the plug without the fuse
cover fitted. Ensure replacement fuse is
the same current value as original.
• Replacement fuses should be ASTA
approved to BS 1362.
• Do not operate any appliance with a
damaged lead or plug, or after the
appliance malfunctions, or has been
damaged in any manner.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
WARNING: This appliance must be
earthed.

SAVE THESE

INSTRUCTIONS

Accessible surfaces of
the toaster may get
hot during use.
In the interest of improving products, Dualit Ltd. reserves the right
to change the product specification without prior notice.
Your Dualit toaster has patented proheat
elements. These elements need to be
conditioned before toasting for the very first
time. Then continue to toast as per the
instructions.
Set the selector switch so ALL the slots
are active, with NO bread in the slots, turn
the timer all the way round and let it run
back to the off position.
Some smoke may vent from the slots,
THIS IS NOT A FAULT and is perfectly
safe. There may be a slight popping crinkling
sound, this is due to heat expansion of the
elements and is perfectly normal.
Your toaster is now conditioned and ready
for use.
SAFETY pRECAuTIONS

READ ALL

INSTRUCTIONS

BEFORE uSING ThE TOASTER

KEEp ThESE INSTRuCTIONS FOR

FuTuRE REFERENCE

•THIS IS AN ATTENDED APPLIANCE.
Do not leave unattended during
use, unplug after each use (risk
of fire if an unattended appliance is left
operating).
• Should the neon light remain
illuminated after using the appliance
immediately unplug the toaster and call
service centre.
• If the timer sticks, unplug and do not
use. Spare timers are available from
www.dualit.com and must be fitted by a
qualified electrical engineer.
• We recommend that the toaster is
plugged into a socket that has no other
appliance connected to it.
Failure to do this may cause an
overload, trip a circuit breaker or blow
a fuse. preferably the socket outlet
should be protected by a Residual
Current device (RCD)
• Before plugging in, check that the
voltage on the rating label is the same
as the mains supply.
• To protect against electric shock, do
not immerse any part of this product
in water or other liquid.
• unplug from outlet when not in use
and before cleaning. Allow to cool
before putting on or taking off parts.
• Do not operate the appliance with a
damaged cord or plug.
• Do not allow cable to touch hot
surfaces, or to hang over edge of a
table or counter top.
• When in use a fire may occur if the
toaster is covered or touching
flammable material.
• Do not attempt to dislodge bread
when the toaster is plugged in.
• Bread may burn. Therefore toasters
must not be used near or below
curtains and other combustible
materials.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
• Children should be supervised to
ensure that they do not play with this
appliance.
• Do not store or use toaster in an
appliance garage or under cupboards.
• Do not use outdoors.
• The toaster is not intended to be
operated by means of an external timer
or separate remote-control system.
IMpORTANT -BEFORE uSING