RESETTING ThERMAL FUSE
If the toaster neon illuminates, but the elements fail to warm up or if there is an audible ‘click’ above the normal ticking of the timer from the toaster while it is still operating, you may have activated the Thermal Protection Device.
Before resetting you must ensure that there is not a fault within the appliance. Do not reset unless a qualified electrician has examined the toaster and verified that the Selector Switch, Timer and all other Components are in good working order.
The Thermal Protection Device can be reset by allowing the toaster to fully cool, unplugging the toaster from the wall socket and following instructions below.
Resetting the Thermal Protection Device should only be carried out by a qualified electrician. The toaster must be Portable Appliance Tested following reset of the Thermal Protection Device. Should you require any further assistance call Dualit’s Service Department on 01293 652 500.
1
U | G |
| |
L |
|
P |
|
N |
|
U | |
| EN |
H | |
W |
|
NO
T
I
N
U
S
E
2 | 3 |
Unplug the toaster | Remove the crumb tray | The fuse can be located in |
and allow to fully cool. | and toaster base plate to | the rear corner of the |
| access the fuse. | toaster body. |
4 | 5 | 6 |
|
| pORTABLE |
|
| AppLIANCE |
|
| TEST |
The fuse is reset by | Refix the base plate and | The appliance must be |
depressing the small white | return the crumb tray. | portable Appliance Tested |
button on its face. |
| before use. |
17
