Dualit IL instruction manual Pouring, Care & Cleaning, Boil-Dry, Water Filter

POURING

The kettle features an oversized non-drip smooth flow spout.

•Remove the kettle from the power base before pouring

•When filling or carrying the kettle, do not tilt it backwards, as this may allow water to pass through the

steam tube onto the control area. Should this happen, the kettle must be allowed to dry before re-using

• To avoid the risk of splashing, once the kettle has boiled wait 10 seconds then pour slowly. Do not

over-tilt the kettle.

WARNINg: If THE kETTLE HAS jUST bOILED, IT WILL bE fULL Of STEAm,WHICH WILL ESCApE AS SOON AS THE LID IS OpENED.

CARE & CLEANING

Regular cleaning & care will keep your kettle looking newer for longer and help prolong the life of the kettle.

•Switch the kettle off, lift it from the power base, unplug

the power base from the wall socket and LET ThE

KETTLE COOL DOWN COMPLETELY BEFORE CLEANING. Wipe the outside and inside surfaces of the kettle with a damp cloth

•If necessary, you may use a mild household detergent.

To clean the filter, see ‘water filter’ section below

• If you use detergent inside the kettle, rinse thoroughly afterwards to remove all traces

• Ensure that all connectors and sockets are kept dry

• Do not immerse the kettle or power base in water or any other liquid

•Do not use harsh or abrasive cleaners or solvents.

U	G
L
P
N
U

	EN
H
W

NO

T

I

N

U

S

E

BOIL-DRY

If the kettle is accidentally switched on with no water inside, the boil-dry device will switch off the heating element to prevent damage to the kettle.

WATER FILTER

DO NOT OpERATE THE kETTLE UNLESS THE WATER fILTER IS CORRECTLy IN pOSITION.

U	G
L
P
N
U

	EN
H
W

NO

T

I

N

U

S

E

•Do not switch the kettle on unless it contains at least one cup of water. Misuse of this kind will shorten the life of the kettle

•If the kettle is accidentally switched on when it does not

• Make sure hands are clean and free from hand cream,

soap or similar, which might leave a slight taint to the
water	PULL OUT
• Remove the kettle from the power base and ensure

contain sufficient water, a boil-dry device will automatically switch it off

• Wait until the kettle has cooled down before refilling. The lid may be hot and the water may spit as it touches the kettle base.

4

4

kettle is cold

• Open the lid. hold the top of the filter, pull up and

out of the kettle. Rinse under a tap while carefully

brushing it with a soft brush. Rinse the kettle out with

fresh water

• To replace, align the filter with the grooves in the filter

holder, insert and push back into place.

10 11