Duracell DRCHCAM user manual

3.Attach your battery onto the base charger unit or onto the appropriate adapter plate and make sure the battery contacts connect with the contact pins. Make sure that the latching on your battery slides completely under the tabs on the charger plate. If the battery is properly connected, the red charging light (CHG) will light up, indicating that the battery is charging. If the red charging light does not turn on, remove the barrel-plug from the back of the charger then re-insert the plug. To ensure that the battery and the charger are properly connected, remove the battery from the charger and reattach. The red charging light will indicate the battery is properly attached and being charged.

Video instructions detailing proper installation of your battery onto the adapter plate can be viewed at www.DuracellDirect.com/support/DRCHCAM.

4.When the green indicator light (FULL) is lit, the battery is fully charged (Fig E).

Fig E

5.In order to maximize the capacity of NiMH and NiCad batteries they should be occasionally discharged. This can easily be done with the charger’s discharge function. Place the battery on the charger and press the large black button on the face of the charger base (Fig F). The battery will begin discharging, and this will be indicated by the yellow light (DIS) turning on. After the battery is fully discharged, it will automatically switch to charge mode until it is completely charged.

Fig F

6.To remove the adapter plate from base charger unit, push down on the top of the plate (Fig G) while sliding the plate to the left (Fig H).

Fig G Fig H

2