•Avoid shaking, dropping, or otherwise shocking the scale. This is a precision instrument and
MUST BE HANDLED WITH EXTREME CARE.
•The scale has been calibrated at the factory and will not need to be calibrated again.
Technical Specifications
Capacity | 20.0 pounds (9 kg) |
Resolution | 0.1 oz. (2 g) |
Units | lb./oz. (kg/g) |
After two minutes of inactivity | |
Operating Temperature | 40° - 104° F (4.5° - 40° C) |
Interface | Serial |
Power | 120 V AC adapter or six AAA batteries |
For information about our other scale products, visit www.dymo.com.
Troubleshooting
Problem/Error Message | Solution |
|
|
No display | Ensure the scale is plugged in, or replace the batteries. |
|
|
LOW BATT is displayed | Replace the AAA batteries. |
|
|
UNDER LOAD is displayed | A Tare value was displayed and the items were removed from |
| the scale. Press Tare (0) to reset the scale to zero. |
|
|
OVER LOAD is displayed | The item on the scale platform exceeds the maximum capacity |
| of the scale. Remove the item immediately to prevent damage |
| to the scale. |
|
|
Display reads 0.0 with an item on the | This can happen because: |
platform | • The Tare button was pressed while an item was on the scale. |
| • Power to the scale was disconnected or turned off and then |
| on again with an item on the scale. |
| In both of these cases, remove the item from the platform and |
| press the Tare (0) button to return the display to 0.0. |
|
|
If you need further assistance, contact Technical Support at (877)
6
