Dynasty Spas 9919-100418-B manual Starting Pump, Setting water temperature, Turning the light on

The Quick Reference Card provides a quick overview of your spa's main

functions and the operations accessible with your digital control pad.

SC-MP-DY1 / Dual-Pump System

Starting Pump 1:

Press Pump 1 to turn Pump 1 on at low speed. Press a second time to turn pump to high speed. Press a third time to turn pump off. When at high speed, a built-in timer turns pump off after 20 min- utes and when at low speed after 2 hours, unless manually deactivated first.

The "Pump 1" indicator lights up when Pump 1 is on at high speed. It flashes when Pump 1 is on at low speed.

Starting Pump 2:

Press Pump 2 to turn Pump 2 on. Press a second time to turn Pump 2 off. A built-in timer automati- cally turns pump off after 20 minutes, unless pump has been manually deactivated.

The "Pump 2" indicator lights up when Pump 2 is on.

Setting water temperature:

Use Up or Down arrow keys to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection.

The "Set Point" indicator displays the desired temperature, NOT the current water temperature!

Water temperature can be adjusted by 1˚ in- crements from 59 to 104˚F (15 to 40˚C).

Temperature display unit:

Press and hold Light key for 5 seconds to display water temperature in either Fahrenheit (˚F) or Celsius (˚C). If a power-up occurs, system re- turns to default setting (˚F).

Turning the light on:

Neptune Series Spas feature an easy-to-change selection of nine different LED color/display settings. To activate the LED lights, press the "LIGHT" button on the topside panel one time. To advance to the next color/display setting, press the "LIGHT" button twice in a row. The LED's will go off with the first press, then back on in the next setting with the second press. If the LED's remain off for more than 5 seconds, the color/display sequence will reset and start back at the beginning the next time the "LIGHT" button is pressed. The color/display sequence is:

Setting #1	LED's light up and slowly cycle throught all six color.
	The slow cycle then restarts at the beginning and repeats.
Setting#2	LED's light up and remain on in Aqua.
Setting#3	LED's light up and remain on in Purple.
Setting#4	LED's light up and remain on in Blue.
Setting#5	LED's light up and remain on in Gold.
Setting#6	LED's light up and remain on in Green.
Setting#7	LED's light up and remain on in Red.
Setting#8	LED's light up for 2 sec, flash off, then flash on in the
next color, until all six colors have been displayed. The flashing
cycle then restarts at the beginning and repeats.
Setting#9	LED's flash on/off quickly, for a strobe light effect.

The LED lights will automatically turn themselves off after 2 hours in any one setting.

Automatic water heater start:

When water temperature is 1˚F (0.5˚C) lower than the Set Point, the heater will automatically turn on until water temperature reaches Set Point plus 1˚F (0.5˚C).

The "Heater" indicator lights up when the heater is on. It flashes when there is a request for more heat but the heater has not yet started.

N.B.: If your system is configured in Low Current Mode, the heater will not start if a pump is on at high speed.

Economy mode:

Press Econo key to switch from Normal mode to Economy mode. In Economy mode, system main- tains temperature at the desired Set Point during filter cycles only. Set Point is 20˚F (11˚C) below the Normal mode Set Point for the rest of the time. In Economy mode, the display will toggle between the current water temperature and the "Econ" message.

Quick Reference Card