4TV componentsDX-32L152A11
3Align the base with the TV, then secure the stand to the TV with
the three screws (ST4 x 14) p rovided.
4Carefully lift the TV into an upright position.
To remove the stand, see the following procedure.

Removing the stand

You must remove the stand before you can wall-mount the TV.
Note: Your TV may differ from the illustrations shown.
To remove the stand:
1Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
2Remove the three screws holding the stand to the TV, then
remove the stand.

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand, if it has been installed.
Warning: These instructions are for use by qualified service personnel
only. To reduce the risk of hazards, do not perform any servicing other
than that contained in the operating instructions unless you are
qualified to do so.
To install a wall-mount bracket:
1Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2Remove the pedestal stand. See “Removing the stand” above.
3Secure the wall-mount bracket to the back of your TV using the
four screws provided with the bracket.
TV components

Front and side controls

Baseplate ST4 screws (3)
Item Name Description
Power indicator Lights red when your TV is in standby mode.
Turns off when the TV is on.
Remote control
sensor
Receives signals from the remote control.
Do not block. For more information, see
“Aiming the remote control” on page7.
MENU Press to open the on-screen menu.
INPUT
Press to open the INPUT SOURCE menu.
For more information, see “Selecting the
video input source” on page11.
VOL / VOL
In TV mode, press to increase or decrease
the volume.
In menu m ode, pre ss to mov e right or left or
to adjust menu settings.
CH /CH
In TV mode, press to select the next or
previous channel.
In menu mode, press to move up or down.
(power)
Press to turn on the TV or put the TV in
standby mode.
Caution: The TV continues to rece ive power
even in standby mode. Unplug the power
cord to disconnect power.
1
2
3
4
5
6
7
DX-32L152A11_10-0615_MAN_ENG_V1.book Page 4 Thursday, July 22, 2010 10:31 AM