Features
• Amplifies 50-900 MHz signals
• Low signal noise
• Flat frequency response
• Ultra stable circuit
• High sensitivity to ensure picture stability and clarity
• Easy installation, including screw brackets for stable wall mounting
• For indoor use only
|
Package contents |
• UHF/VHF/FM amplifier |
• Screws (2) |
Setting up your amplifier
1 To attach the amplifier to a wall, drill two pilot holes 4.53 in. (115 mm) apart and install wall anchors (if mounting to a brick or hollow wall) before securing with the two provided 
screws.
Tip: Attach the amplifier to the wall or |
| |
baseboard as close as possible to | 4.53 in. (115 mm) | |
where the antenna cable enters the house. | ||
|
2Attach a
Tip: If your antenna is equipped with a
• Quick Setup Guide |
|
Specifications |
|
|
|
Bandwidth |
|
|
|
Gain | 4.5 dB |
|
|
Response flatness | ±2 dB |
|
|
Maximum output (IMA 60 dB) | 86 dBμV |
|
|
Noise figure | 5.5 dB |
female | 75 | cable |
matching transformer | ||
(not included) before |
|
|
connecting to the |
|
|
amplifier. |
|
|
3 Attach additional |
|
|
| 75 | cable |
cables (not included) from the |
|
|
OUT connectors on the amplifier to the RF inputs of each video device you want to connect.
75
/300
matching transformer
75cable or
300 flat wire
Impedance | Input | 75 ohm x 1 | |
Output | 75 ohm x 4 | ||
| |||
|
|
| |
Connectors |
| “F”female | |
|
|
| |
Power requirement | 120V ~ 60 Hz 0.02A 2.4W | ||
Tip: If you are not using all four
outputs on the amplifier, we recommend that you cap the unused outputs with a
75-ohm terminating resistor (not included) to prevent signal loss.
4Plug the amplifier into an AC power outlet. Your amplifier is now in operation.