Dynex DX-FMDC1 manual USB Type A to mini-USBcable included, 1Find the FM frequency you want

DX-FMDC1 - English only.fm Page 5 Tuesday, September 12, 2006 4:45 PM

Using the mobile FM transmitter and charger 5

For MP3 players with mini-USB connectors, use the Male

USB Type A to mini-USB cable (included).

Note: To disconnect, unplug it from the MP3 player.

4Plug the 3.5 mm audio cable (included) into both the mobile FM transmitter and your MP3 player.

5Start your MP3 player. Your mobile FM transmitter turns on when an audio signal is detected.

6Select the frequency from Step 2 above using the up and down arrows on the front of your mobile FM transmitter.

Tip: The mobile FM transmitter works best when the MP3 player volume is set between 50% to 75% of maximum. After you have tuned to the frequency and begun transmitting, adjust the volume to a comfortable level.

Tip: Your MP3 player does not automatically turn off. Be sure to turn it off before exiting your car.

To use the mobile FM transmitter presets:

1Find the FM frequency you want.

2Firmly press and hold one of the three preset buttons on the front of the mobile FM transmitter until the display lights blink (usually 2-3 seconds). This stores the station in memory.

A small indicator bar appears on the display.

3Repeat steps 1 and 2 to store two additional stations with the two remaining buttons.

Tip: When the mobile FM transmitter is turned off and restarted, it tunes to the last frequency used.