Dynex DX-WD1335 11, DX, -, WD, 1335, Step 6:

1335

Step 6:

Caution: Check the parts carefully before assembling. Dis assembly of glued part s is extremely difficult.

1Fill the holes in the stop molding (J) 1/4 to 1/2 full with glue (R), then insert the wood dowels (P) into the holes.

Wipe away the excess glue.

2Drop a few beads of glue (R) into the holes in the ends (A and B).

3Align the ends (A and B) and the back (E) with the top (C) and the stop molding (J). Make sure that the dowels,

Twist-l ock® fasteners, and cam dowels align with the correct holes, then tighten the four hidden cams and two

Twist-l ock® fastener s.

Note: Wipe away the excess glue with a damp cloth.

You’ll need:

To use a Twist-lock®

fastener:

1Insert the dowel end

of the fastener into the

hole of the adjoining

part.

Note: The dowel end of

the fastener must

remain fully inserted

in the hole of the

adjoining part while

locking the fastener.

2Tighten the fastener

with a Phillips

screwdriver as tight as

possible.

Dowel end

Surface with

Twist-lock

fastener

Surface with hidden cams

Arrow

Maximum: 210°

Minimum:

190°

Fill the holes 1/4 to

1/2 full with glue.

Phillips screwdriverP (2) R (1)