Dyson 1741801 manual Assembly

Models: 1741801

1 12
Download 12 pages 13.85 Kb
Page 8
Image 8
ASSEMBLY

ASSEMBLY

Lie vacuum cleaner flat and push on cleaner head until it clicks. Stand vacuum up straight, insert wand into hose and push into place until it clicks. Attach tool to the side of the vacuum cleaner.

USING YOUR DYSON VACUUM CLEANER

Press foot pedal and recline handle to use. The stabiliser stand will automatically lift up. To switch ‘ON’, depress power button in front of handle. When finished cleaning, push vacuum cleaner into an upright position and stabiliser wheels will automatically drop. Use the carrying handle to carry the vacuum cleaner.

CAUTION:

When returning to the upright position, ensure that the stabiliser wheels are fully engaged before releasing the cleaner.

Do not press the cyclone release button while carrying the vacuum cleaner or it could fall and cause injury.

PLEASE NOTE:

Fine dust such as plaster or flour should only be vacuumed in very small amounts.

Consult your flooring manufacturer’s recommended instructions before vacuuming and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating brushbar is used when vacuuming. If this is the case, we recommend vacuuming in hard floors mode and consulting with your flooring manufacturer. (Refer to carpets/hard floors section.)

If used in a garage when car cleaning, care should be taken to wipe the soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt, or pebbles which could damage delicate floors.

CARPETS/HARD FLOORS

The brushbar will always default to ‘ON’ (spinning) each time you switch on the vacuum cleaner and recline it for cleaning. The brushbar will automatically stop if it becomes obstructed. If the brushbar stops during use, please refer to the ‘Clearing brushbar obstructions’ section.

To switch the brushbar off (e.g. for hard floors), recline the vacuum cleaner and turn it ‘ON’, then press the brushbar ‘on/off’ button – the brushbar will stop spinning.

HIGH-REACH CLEANING

CAUTION:

Switch ‘OFF’ the vacuum before changing tools.

Powerful suction can cause the hose to ‘pull back’ – please take care.

Take extra care when vacuuming on stairs; do not work with the vacuum above you on the stairs. Do not put the vacuum on chairs, tables etc.

Ensure vacuum is in upright position before using tools.

PLEASE NOTE:

To release the wand, open the wand cap and pull the red tube until the wand releases from the vacuum. Tools can be attached to either the hose or wand.

The brush bar will not rotate when the vacuum is in an upright position.

Ensure wand cap is closed when not in use.

CLEAR BIN EMPTYING

CAUTION:

Switch ‘OFF’ and unplug the vacuum cleaner before emptying the bin.

Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. To remove the clear bin from the vacuum cleaner press the button at rear of carrying handle. To release the dirt, press the red bin release button.

To minimize dust/allergen contact when emptying, encase base of bin tightly in a plastic bag before trigger releases dirt. Remove bin carefully and seal bag tightly, dispose as normal.

PLEASE NOTE:

Do not use the vacuum cleaner without the clear bin in place.

CLEAR BIN CLEANING

CAUTION:

Do not immerse the whole cyclone in water or pour water into the cyclones.

Ensure the bin is completely dry before replacing.

PLEASE NOTE:

Do not use detergents, polishes or air fresheners to clean the bin.

Do not put the bin in a dishwasher.

When vacuuming, certain carpets may generate small static charges in the clear bin. These are entirely harmless and are not associated with the mains supply. To minimise any effect from this, do not put your hand or insert any object into the clear bin unless you have first emptied it and rinsed it out with cold water.

Clean the shroud with a cloth or dry brush to remove lint and dust.

WASHING YOUR FILTERS

DO THIS EVERY 3 MONTHS

CAUTION:

Switch ‘OFF’ and unplug the vacuum cleaner before removing the filters.

Ensure filters are completely dry before refitting into the vacuum cleaner.

PLEASE NOTE:

This vacuum cleaner has two filters, located as shown. It is important to check your filters regularly and wash at least every 3 months according to instructions.

The filter in the ball should be rinsed and tapped out until the water runs clean, then tapped out again to ensure all excess water is removed. Please leave to dry completely for 24 hours.

It is normal for the filter in the ball to turn grey in colour. The filters may require

more frequent washing if vacuuming fine dust.

Do not use detergents to clean the filters.

Do not put the filters in a dishwasher, washing machine, tumble dryer, oven, microwave or near an open flame.

LOOKING FOR BLOCKAGES

CAUTION:

Switch ‘OFF’ and unplug the vacuum cleaner before checking for blockages.

Please ensure vacuum cleaner is upright before removing hose or airway inspection parts.

Beware of sharp objects when clearing blockages.

Refit all parts of the vacuum cleaner securely before using.

PLEASE NOTE:

Clearing blockages is not covered by your vacuum cleaner’s limited guarantee. If any part of your vacuum cleaner becomes blocked, it may overheat and then automatically shut off. Unplug the vacuum cleaner and leave to cool down.

Clear blockage before restarting.

CLEARING Brush bar OBSTRUCTIONS

CAUTION:

Switch off and unplug the vacuum cleaner before clearing brushbar obstructions. Failure to do so could result in personal injury.

If your brushbar is obstructed, it may shut off. If this happens you will need to remove the brushbar as shown and clear any obstructing debris.

CONFORMITY INFORMATION

The symbol Manual background on the product or on its packaging indicates that this product should not be treated as household waste. Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment – this may be your local civic amenity site or a facility provided by the retailer selling the product or a replacement product. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and for human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact the Dyson Customer Care Helpline, your local authority civic amenity site or the retailer selling the product or a replacement product.

GUARANTEE – TERMS AND CONDITIONS DYSON CUSTOMER CARE

If you have a question about your Dyson vacuum cleaner, call the Dyson Customer Care Helpline with your serial number and details of where and when you bought the vacuum cleaner, or contact us via the website. The serial number can be found on the main body of the vacuum cleaner behind the clear bin. Most questions can be solved over the phone by one of our Dyson Customer Care Helpline staff.

If your vacuum cleaner needs service, call the Dyson Customer Care Helpline so we can discuss the available options. If your vacuum cleaner is under guarantee, and the repair is covered, it will be repaired at no cost.

PLEASE REGISTER AS A DYSON machine OWNER

THANK YOU FOR CHOOSING TO BUY A DYSON VACUUM CLEANER.

To help us ensure you receive prompt and efficient service, please register as a Dyson machine owner. There are three ways to do this:

Online at www.dyson.co.uk

By calling the Dyson Customer Care Helpline.

By completing and returning the enclosed form to us by mail.

This will confirm ownership of your Dyson vacuum cleaner in the event of an insurance loss, and enable us to contact you if necessary.

LIMITED 5 YEAR GUARANTEE

Terms and conditions of the Dyson 5 year limited guarantee.

WHAT IS COVERED

The repair or replacement of your vacuum cleaner (at Dyson’s discretion) if your vacuum cleaner is found to be defective due to faulty materials, workmanship or function within 5 years of purchase or delivery (if any part is no longer available or out of manufacture Dyson will replace it with a functional replacement part).

Use of the vacuum cleaner in UK and Ireland.

WHAT IS NOT COVERED

Dyson does not guarantee the repair or replacement of a product as a result of:

Normal wear and tear (e.g. fuse, belt, brush bar, batteries etc).

Accidental damage, faults caused by negligent use or care, misuse, neglect, careless operation or handling of the vacuum cleaner which is not in accordance with the Dyson Operating Manual.

Blockages – please refer to the Dyson Operating Manual for details of how to unblock your vacuum cleaner.

Use of the vacuum cleaner for anything other than normal domestic household purposes.

Use of parts not assembled or installed in accordance with the instructions of Dyson.

Use of parts and accessories which are not Dyson Genuine Components.

Faulty installation (except where installed by Dyson).

Repairs or alterations carried out by parties other than Dyson or its authorised agents.

If you are in any doubt as to what is covered by your guarantee, please call the Dyson Customer Care Helpline.

8

Page 8
Image 8
Dyson 1741801 manual Assembly