Eagle Electronics II

POWER CONNECTIONS OPS MODULE SELF-TEST

The AccuNav

II works from a twelve-volt battery system. For the best

results, attach the power cable

directly to the

battery. You can attach the

power

cable to an accessory

or power

buss, however you may have

problems with electrical interference.

Therefore, it's saferto

ahead and

attach the

powercable directlyto

the

battery.

If the cable is too

short, splice

#18

gauge

wire onto it. The

power

cable has four

wires; red, black, green,

and white. Red is the

positive lead, black is negative or ground. Make

certain to attach the in-line

fuse holder to the red lead as close to the

power

source as possible. For

example, if

you

have to extend the

power

cable to

the

battery

power buss,

attach one end of the fuse holder

directly

to the

battery

power

buss. This will protect both the unit

and the

power

cable

in the event of a short. The AccuNav II uses a 3-amp fuse.

IMPORTANT!

Do not use this product

without a

3-amp fuse wired into the

power

cable!

Failure to use a

3-amp

fuse will void your warranty.

This feature tests the UPS module and returns a

special

code. This code

is of interest only to the service

department. However,

the AccuNav II

interprets this code and displays a status

message.

This

message is either

"MODULE HAS PASSED" or "MODULE HAS FAILED" and shows at the

bottom of

the

screen. The

current software version number also

appears

near the bottom of the screen. Contact the factory customer service

department if the module fails the self test. Do not attempt to use this

product if

fails the self

test.

To use the self test feature,

pressthe

keytwicewhile

it's in the UPS

mode, then

press

the

key next to the "UPS MOD-

ULE SELF TEST" label. The

screen shown at

right appears.

exit

from this screen, press

the

CLEAR key.

GPS SIMULATOR

This feature places position and navigation data on all screens, including

the

plotter. The unit "navigates" a closed course. It shows bearing and

distance to go, course over ground, and other information. A recurring

message appears, alerting you

that the simulator mode is enabled. Don't

navigate when the simulator is on!

To turn the simulator

on, press the MENU key

twice, then press the key

next to the "UPS SIMULATOR OFF ON" label. The simulator mode starts

immediately. To turn the simulator off,

either press

and hold the OFF

key

or repeat the above steps. Press the

key

next to the "UPS SIMULATOR

OFF ON" label.

AccuNav II POWER CONNECTIONS

2 43

TO "P' CONNECTOR

ON ACCUNAV II

P CPS SELF TEST

BIT SUMMARY 0000

LOW ORDER RAM FFFF

HIGH ORDER RAM FYFF

PRE PROCESS TEST 0000

PRE PROCESS RAM FEFF

MULTI INTERFACE 0000

LICO TEST 0000

SIGNAL INJS 0000

0FTWARE_VERSION 320

CLEARI

WHITE

WIRE

NMEA

INTERFACE

MODULE HAS PR RED

RED

WIRE

3 amp

FUSE

DOPS

BEACON

RECEIVER

PDF compression, OCR, web-optimization with CVISION's PdfCompressor