Eagle Electronics II

The plotter display automatically shows a .1 mile display in the Man Pole Mount

Overboard mode. Your position when the Man Overboard key was

pressed

is shown by

the "S" with a circle and by the

waypoint icon with a

"0" Steer to the

waypoint flag to

get

back to the

position saved when the

Man Overboard key was pressed.

IMPORTANT!

The AccuNav II doesn't save the Man Overboard position in the

waypoint

table.

However, it does save the

position on the Man Overboard screen.

The AccuNav II

always

shows navigation

data to the

position

shown on the

Man Overboard screen whenever the Man Overboard key

pressed. To

stop

the unitfrom

navigating

to the Man Overboard position, press

the

key

next to the "DISABLE MOB" label. This resets the Man Overboard

navigtion.

For

example, suppose you

are

viewing

the Position screen, and

you press

the Man Overboard key, then press the GPS key. The AccuNav II first

displays then stores your present position

on the Man Overboard

screen,

then

switches backto the Position screen. If

you press

the Man Overboard

key again, itwill still show navigation

data to the

position you

were in when

you first pressed the Man Overboard key - not your present position.

Repeated pressing

of the Man Overboard key

does not

repeatedly save

your present position!

The unit

onlysaves

the

position

thefirsttimethe Man

Overboard key

is pressed. To save a new Man Overboard postion. you

must first clear the old Dosition by Dressing the key adiacent to the

"DISABLE MOB" label.

You can navigate to a waypoint using the Waypoint Recall feature,

however when you go back to the Man Overboard screen, the AccuNavll

stops navigating to the recalled

waypoint.

Remember, saving

the victim is the

primary goal. Try

all

options to rescue

the person immediately

after the

accident

happens. Training and educa-

tion are also good accident preventatives.

The Coast Guard has

excellentsafetycourses. Instructall members on board yourboat

safety

procedures

before leaving

the

dock. Make certain all on board know what

to do before any emergency occurs.

First, thread the

pole mounting adapter onto the mounting pole

or ratchet

base. Align the pole mounting adapter so the module will face the bow of

the boat. Install and tighten the set screw into

the pole mounting adapter

and tighten it securely. This should prevent the GPS module from

unscrewing from the pole. Place the gasket onto the pole mounting

adapter. Now attach the cable to the GPS module and pass

the cable

through the gasket, pole mounting adapter, and pole. Set the GPS

module on

top

of the pole mounting adapter and align

the four threaded

holes in the module with the holes

in the pole mounting adapter. Using

the four stainless steel 5 mm screws and lock

washers

supplied

with the

AccuNav II, attach the pole mounting adapter to the GPS module. This

completes the assembly.

POLE

MOUNTING

ADAPTER

If the pole

or mast you're using

isn't hollow or

if the hole in the middle of

the

pole

is too small for the connectors, use the cable

mounting adapter

supplied

with

your

unit. Thread the cable

mounting adapter

into the OPS

pole mounting adapter. Then thread the pole into the cable mounting

adapter. Route the cable down the outside

of the pole.

SET

SCREW POLE

DULE

CABLE

MOUNT-

ING

ADAPTER

POLE

CABLE

MOUNT-

ING

ADAPTER

POLE

PDF compression, OCR, web-optimization with CVISION's PdfCompressor