Earthquake Sound MC6 specifications Custom Speaker Installation, Factory Replacement Installation

CUSTOM SPEAKER INSTALLATION			NOTE:
GRILLE 4 S H E E T M E T A L		GRILLE TRAY	INSTALLATION APPLIES
	SCREWS PER SPEAKER
			TO BOTH COMPONENT
			AND COAXIAL SPEAKERS

FACTORY REPLACEMENT INSTALLATION			NOTE:
4 S H E E T M E T A L	SPEAKER FACTORY CUTOUT	MOUNTING CLIPS	INSTALLATION APPLIES
SCREWS PER SPEAKER
			TO BOTH COMPONENT
			AND COAXIAL SPEAKERS

SURFACE MOUNT				FLUSH MOUNT COMPLETE ASSEMBLY
				Cut diameter: EQM-T=2.15” (54.7mm)
Cup Mount				Push assembled tweeter through cut out hole
First	pre - wire
your	water		craft
if not using stock					Fasten the panel
p l a c e m e n t .
				Panel	clamp down from
Mount		cup in
desired		place.			behind the panel.
T h e n		p u s h		Twist on nut	Panel Clamp
tweeter		inside		until the
cup	until		you	tweeter is
hear	the		snap.	secured
This	indicates
a secure fit.

NOTE:

Hand tighten the screws in a crisscross pattern to avoid bending the speaker basket or stripping screws.

All specifications are subject to change without notice.

COMPONENT SET WIRING DIAGRAM

WOOFER TWEETER

AMPLIFIER

CROSSOVER

6 EARTHQUAKE SOUND EARTHQUAKE SOUND • INSTALLATION 7