OPERATING INSTRUCTIONS and parts explosions
Front Tine Models
controls
Drive SAFETY Control Lever
Engage tines into forward, releasing returns machine to neutral.
Pulling down on drive safety control lever engages the tines. Releasing the drive safety control lever disengages the tines to a neutral position.
BELT TENSION ADJUSTMENT
Proper belt tension is critical to good performance. After 1/2 hour of operation, all cables may have to be adjusted due to initial stretch. Thereafter, check tension after every 2 hours of operation.
To increase belt tension:
1.Loosen upper jam nut. Turn nut up cable in 1/8” increments.
2.Tighten lower jam nut.
3.Check adjustment.
This procedure can be repeated until conduit adjustment bolts have no more adjustment left. If no more adjustment can be made, belt may have to be replaced.
DEPTH REGULATOR LEVER
Tilling depth is controlled by the height of the depth regulator lever.
To adjust tilling depth.
1.Remove detent pin.
2.Raise the depth regulator lever to position tines at chosen tilling depth.
3.Align hole in depth regulator lever with hole in depth regulator bracket and replace detent pin.
drive safety control lever disengaged
1/4” stretch
upper jam nut lower jam nut
forward cable
Model 3365/3365CE Handlebar
!CAUTION
This information is provided here only to introduce the controls. DO NOT START THE ENGINE ATTHISTIME. Starting and operating instructions are given on page 10. Please read this section and all operating and safety instructions before startingyour tiller.
•As a safety precaution,the drive safety control lever will not lock in the forward position.
•To stop the wheels and tines at any time release the drive safety control le- ver.
!WARNING
ENGINE SHOULD BE OFF BEFORE ADJUSTING ANY CONTROLS.
Do not adjust tilling depth unless drive safety control lever is released to the neutral position.
drive safety control lever disengaged
1/4” stretch
upper jam nut
lower jam nut 
forward cable 
Model 3365PS/R3365H Handlebar
Page
