110, 230, and 450 Series Steering Control Units
10
23 Lubricate and install 72,6 mm [2.86 in.] ID seal in spacer plate or
gerotor (meter), (ref.) see note page 2. The lubrication will hold seal in
place.
24 Align star valleys (reference A) with marked drive (reference B).
Valleys must align with pin. Note parallel relationship of reference
lines A, B, C, and D in figure 25. Align bolt holes without disengaging
gerotor (Meter) from drive.
25 When used, install drive spacer in gerotor (meter), see chart
figure 26.
26 Lubricate and install 72,6 mm [2.86 in.] ID seal in gerotor (meter)
or end cap, current end cap does not have the o-ring groove (ref. – see
note page 20).
27 Install end cap on gerotor, aligning holes.
Seal
Seal Groove this
Side -002 Unit.
See Note inside
Front Cover
(page 2)
A
B
C
D
Port Face
Pin
Drive (Marked)
Meter
(Gerotor)
Star Valley
O-ring Groove this
Side -002 Unit —
Old Spacer Plate
has No O-ring
Groove
Seal Groove this
Side -002 Unit.
See Note
Inside Front
Cover (page 2)
Drive Spacer
Seal End Cap
Seal washers are not used with 6 point (E10) or
hex head screws and -002 end cap (-002 end cap does not
have a o-ring groove).
Cap Screw
Actual
Displacement
cm
3
/r
[in
3
/r]
75 [ 4.5]
95 [ 5.9]
120 [ 7.3]
145 [ 8.9]
160 [ 9.7]
185 [11.3]
230 [14.1]
295 [17.9]
370 [22.6]
460 [28.2]
590 [35.9]
740 [45.1]
None
3,56 [ .140]
6,10 [ .240]
10,29 [ .405]
12,19 [ .480]
15,62 [ .615]
21,97 [ .865]
28,45 [1.120]
41,15 [1.620]
53,67 [2.113]
66,37 [2.613]
91,77 [3.613]
Length mm [in.]
Item No. 5
Spacer
None
None
45 [ 2.8]
60 [ 3.6]
Reassembly