6. FAN VENTS
Do not obstruct the ventilation openings of the amplifier.
7. SPEAKER OUTPUTS
Connect your speakers to these output screw terminals. The hookup diagrams on page 10 show how to connect your speakers in various ways.
There are three pairs of terminals. Use the two outer pairs (CHANNEL A and CHANNEL B) when using stereo or mono modes.
Use the center pair (BRIDGED) when using bridge mode.
Note: When using bridge mode, your speaker's average impedance must be 4 ohms or greater.
This terminal strip is normally covered by a protective cover. Remove the two screws and the cover while making or undoing connections. Securely refit the cover when you have finished making the connections.
8. BREAKER
9. POWER CORD SOCKET
Here is where you connect the detachable power cord included with your amplifier. Plug the other end of the power cord into an AC outlet properly configured with the voltage required for your particular model.
Be sure the AC outlet can supply enough current to allow full power operation of all the amplifiers plugged into it. The outlet should be a
This is a resettable circuit breaker that monitors the amount of current being drawn by the amplifier. Under normal operating conditions, this should never pop. An unusual condition may cause the breaker to pop, such as a mains voltage surge occurring at the same time as a peak amplifier output.
Turn the POWER switch off, and push the BREAKER button in to reset the circuit breaker. Turn the POWER switch back on and the amplifier should resume normal operation. If the circuit breaker pops again, something probably isn’t right.
•Make sure that the total impedance of the speakers
connected to the outputs is 2 ohms or greater (per channel) in stereo mode, or 4 ohms or greater in bridged mode.
•If the breaker pops right away, even with the Level controls turned down and the speakers disconnected, there may be something wrong inside the amplifier.
B (+)
B
GND
A 
A (+)
PUSH
LINE
(BALANCED)
PUSH
LINE
(BALANCED)
INPUT | INPUT | |
B |
| CONNECTION |
|
| |
OFF | ON |
|
SUBSONIC |
| |
FILTER AT 30Hz |
| |
|
| AMP MODE |
INPUT | MONO | |
| ||
A |
| STEREO |
|
| BRIDGE |
OFF | ON |
|
CLIP LIMIT |
| |
6 | 7 | 8 | 9 |
|
|
| CAUTION |
|
| TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, | |
DO NOT EXPOSE THIS APPARATUS TO RAIN OR | |||
MOISTURE. SEE INSTRUCTIONS BEFORE USING. | |||
|
| BREAKER | SERIAL/DATE CODE |
CHANNEL B | BRIDGED | CHANNEL A |
|
B (+) B | (+) | A (+) A | MANUFACTURED IN CHINA |
2004 LOUD TECHNOLOGIES INC. | |||
|
|
| "EAW" IS A REGISTERED TRADEMARK |
|
|
| OF LOUD TECHNOLOGIES INC. |
6 – CAZ Series