ASSEMBLY | 99944200600 |
|
|
Install Handle/Barrier Bar
Note: The Barrier Bar is required when using grass or weed blades. Units equipped with
1.Remove screws and nuts and back plate from handle.
2.Position front handle on shaft and install Barrier Bar using 5x35 mm screws and new nuts included with kit. Handle must be at least 10 inches (250 mm) from center of rear handle grip.
3.Adjust handle position for comfortable operation, and tighten screws securely.
1.Remove screws and nuts and back plate from handle.
2.Position front handle on shaft and install Barrier Bar using
5x35 mm screws provided in kit. Handle must be at least 10 inches (250 mm) from center of rear handle grip.
3.Adjust handle position for comfortable operation, and tighten screws securely.
Note: The Barrier Bar is not a handle.
Blade Installation
Install Metal Shield
1.Loosely attach bracket (A) to shield (B) and attach to bottom of gear housing (C) with screws and nuts provided. Tighten all hardware.
Install Blade
1.Install upper plate (D) on splined PTO shaft, pilot side down. Blade installation requires Upper Plate (D) with 20 mm pilot.
2.Place Blade (E) over upper plate pilot, install the Lower Plate (F) and 10mm LH nut (G).
3.Insert Locking Tool (K) through hole in upper plate and notch in gear housing to prevent PTO shaft from turning. Tighten nut and secure with Split Pin (L).
Blade Upper Plate
D
12 | X7702273307 |
© 2/2014 ECHO Inc.