99944200513 | OPERATION |
|
|
1.The tilling width of the cultivator is approximately 165 mm (6.5 in.). Place cultivator in area to be tilled, hold unit firmly with left hand on front grip and right hand on rear grip and gradually engage throttle trigger. Guide the cultivator allowing the tines to pullforward. The soil hardness will control tilling speed.
2.The cultivator attachment is capable of tilling in the forward or reverse direction. For deep soil tilling, till forward then lightly pull unit rearward allowing the tines to make a deeper cut into the soil. Deep soil cultivating can also be enhanced by repositioning the tines. (Refer to Tine Setting).
3.To raise or aerate the soil, tilt engine closer to the ground which will raise cultivator tines higher relative to the soil surface.
Do not operate cultivator underwater. The gear housing is not sealed and water will wash away lubrication, damaging gears, bearings, and seals.
Resetting Tines for Deep Cultivation
The tines are factory assembled with blade ends offset for standard cultivation. For deep cultivation, the left tine (viewed from the operator's position) must be repositioned on the hub aligning the left and right tine blade ends directly across from each other.
X7702093305 | 13 |
© 08/2013 ECHO Inc.
