10 
OPERATION
NOTE
Refer to your Pro Attachment Series power source or Split Boom Operator's Manual for correct engine fueling, starting and stopping instructions.
IMPORTANT
Guide bar cover is for travel/storage only. Remove cover before using unit.
LUBRICATING THE GUIDE BAR AND SAW
CHAIN
Automatic Oiling System
1.Wipe debris from around oil fill cap.
2.Remove oil fill cap and fill reservoir with a quality, low viscosity guide bar and saw chain oil.
NOTE
The discharge volume of the automatic oiler is preset to deliver 3 to 4 cc/min. at normal operating RPM. During heavy or dry cutting conditions the oil discharge volume may be adjusted to assure adequate lubrication. Refill the oil reservoir with each tank of fuel.
IMPORTANT
To prevent plastic deterioration, do not use synthetic or silicone based oil.
ADJUSTING AUTOMATIC OILER
Tools required: 10 mm (13/32 in.) Wrench, Screwdriver
1.Remove two (2) 10 mm guide bar retaining nuts and sprocket cover.
2.From bottom of gear case, turn adjustment screw (A) clockwise to decrease oil volume - counter clockwise to increase oil volume.
NOTE
Very little visible oil on the saw chain will provide sufficient lubrication.
A