WARNING

Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may cause severe kickback resulting in serious injury.

Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard when tested on the representative sample of chain saws below 3.8 C.I.P. specified, and the Echo guide bar specified.

IMPORTANT

Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.

IMPORTANT

If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa. com.

Refer to your Chain Saw Safety Manual for kick guard application information.

setting the saw chain

For setting saw chains, round file (4 mm ø: 5/32”) and flat file are used.

To keep correct position and correct angle, use the file holder.

-Round file and flat file are available from your Echo Dealer.

File cutters as below.

To sharpen other type chain, follow chain manufacturer’s instructions

30°

Keep this angle

PUSH FILE AS SHOWN

Type : 91VG

90°

HOLD FILE HOLDER

LEVEL

1/5

Depth

 

gauge

ONE FIFTH OF FILE DIAMETER REMAINS ABOVE CUTTER EDGE

Place the depth gauge tool firmly on guide bar so that depth gauge protrudes. Then file top of depth gauge with flat file until flat with top of the gauge tool.

-Be sure to round off the front edge of the depth gauge.

Depth gauge

 

 

tool

 

Round

 

Remove

 

off the

 

until flat

 

edge

 

with tool

 

 

24