Echo CS-352 instruction manual Bucking, Operation

OPERATION CS-352

Bucking

Bucking is the sawing of a log or fallen tree into smaller pieces. There are a few basic rules which apply to all bucking operations.

•Keep both hands on the handles at all times.

•Support logs if possible.

•When cutting on a slope or hillside, always stand uphill.

Keep in mind that the wood is heavy and that it will bend and pinch the saw if improperly supported. The trunk will weaken at the point where you make the cut unless the tree is lying on perfectly flat ground or supported as shown. If you make the cut with the tree on the ground, don’t let the saw’s chain dig into the earth; it is harmful for the saw, and you stand a good chance of being struck by flying debris.

To cut the trunk, use the bucking and two-cut sequence shown. The first cut should be no deeper than one-third the trunk diameter.

26

Uphill position

Finish cut

First cut

Support

When the bar nose hits another tree, etc.

X7503272504

© 08/2013 ECHO Inc.