Unlock chain brake
Proper tension Improper tension
5.Mount guide bar on studs and slide toward clutch to make saw chain installation easier. Install chain with cutters on top of guide bar facing foward.
6.Slide bar forward and ensure tensioner pin fits into lower adjustment hole.
7.Unlock the chain brake, and install the clutch cover over the guide bar studs. Ensure brake band is positioned around clutch drum, and tab at rear of clutch cover fits underneath tab on engine cover. Tighten clutch cover nuts finger tight.
8.Turn saw over and check brake band for correct position on clutch drum. If brake band is not in place around drum, remove cover, make sure brake is unlocked, and reinstall. Tighten clutch cover nuts finger tight.
WARNING
Improper clutch cover assembly can result in serious injury, and will cause severe saw damage if unit is started. Never start or operate saw if brake band is not in place on clutch drum. Always check chain brake operation after replacing cover. Do not use saw if chain brake does not function properly.
ADJUSTING CHAIN TENSION
IMPORTANT
Always loosen clutch cover nuts before turning the chain tension adjuster, otherwise the clutch cover and tensioner will be damaged.
1.Remove spark plug lead. (See page 24)
2.Loosen two clutch cover nuts, if necessary.
3.Hold the bar nose up, and turn the adjuster screw clockwise until chain fits snugly against underside of the bar.
4.Tighten both nuts with the bar nose held up.
5.Pull the chain around the bar by hand. Loosen the adjustment if you feel tight spots.
6.When chain is properly tensioned, tighten clutch cover nuts securely - 20 to 23 N·m (200 to 230 kgf·cm).
7.Keep chain properly tensioned at all times.
11 |