10
ASSEMBLY
PLASTIC SHIELD
Tools Required: None
1. Remove wing nut (C), washer (B), and bolt (A).
2. Snap the shield over the bearing housing.
3. Install bolt (A), washer (B) and wing nut (C).
NYLON LINE HEAD
Tools Required: Head Locking Tool, 9/16 in. Socket
Parts Required: Rapid LoaderTM Head.
1. Remove plastic threaded shaft sleeve from PTO shaft.
2. Align locating hole in upper plate with hole in bearing housing and
insert 1/8 in. diameter locking tool (A).
3. Place large washer then line head on threaded shaft followed by
small metal washer and locknut.
4. Tighten locknut securely.
IMPORTANT
Remember to remove the locking tool.
NYLON LINE REPLACEMENT
Tools Required: None
Parts Required: Two (2) ECHO 0.080 (2 mm) Nylon Trimmer Line
203 mm (8 in.) long
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (A) in housing until ends
meet in center of recess.
A
B
C
A
A