MAINTENANCE | |
|
|
1.Clean dirt from the grease fitting (A).
2.Apply
3.Wipe excess grease from around grease fitting.
A
Blades
Blades should only be removed and reinstalled by an Authorized ECHO Servicing Dealer, otherwise premature wear or internal damage may occur.
Sharpening
Level 2.
Parts Required: none
Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.
1.Move stop switch to stop position.
2.Disconnect spark plug wire.
3.Remove blade guard, if installed (see “Blade Guard Remove/Install instructions”).
4.Slide blades to allow file clearance using slots (A) on bottom of blade. Do not pry against cutting edges.
5.File each edge carefully. Follow the original shape of the blade.
If a power grinder is used DO NOT allow blade to over heat.
6.Install blade guard, if necessary (see “Blade Guard Remove/Install instructions”).
7.Lubricate blades (see “Lubrication”).
26
A
6 mm (.25 in.) radius
45o
X7502256706
© 9/2013 ECHO Inc.