HEDGE CLIPPER 17

OPERATOR'S MANUAL

4.START-PULLROPE

Lay the hedge clipper on a flat clear area and pull the recoil starter handle (D) until engine fires.

5.OPENCHOKE-RUN.

Move choke (B) to the RUN (OPEN) position. Restart engine if necessary and allow unit to warm up at idle for several minutes.

WARNING DANGER

The blades should not move at idle. If blades move, readjust carburetor according to "Carburetor Adjustment" instructions in this manual or see your ECHO Dealer, otherwise serious personal injury may result.

6.After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.

H L

COLD START B

RUN

IDLE

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close the choke.

WARNING DANGER

The blades should not move at idle. If blades move, readjust carburetor according to "Carburetor Adjustment" instructions in this manual or see your ECHO Dealer, otherwise serious personal injury may result.

1.STOP SWITCH - START/RUN

Move stop switch (A) away from the STOP position.

2.START - Pull Rope

Lay the hedge clipper on a flat clear area and pull the recoil starter handle (D) until the engine fires.

NOTE

If engine does not start after 5 pulls, use Cold Start Procedure.