22

Gear Box Assembly

Level 1.

Tools required: Grease Gun, Clean rag

Parts required: POWER BLENDXTM 14 oz. (P/N 91015) or Lithium Based Grease.

1.Clean dirt from grease fitting.

2.Apply 1-2 pumps of grease into fitting, DO NOT over fill. Leave room for the grease to expand during operation.

sharpening blades

Level 3.

Tools required: Flat file, Screwdriver

Parts required: None

WARNING

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.

1.Disconnect spark plug wire.

2.Slide blades to allow file clearance using slots on bottom of blades.

Do not pry against cutting edges.

3.Follow the original shape, and file each cutting edge carefully to avoid damage to adjacent teeth. Maintain 6 mm (.25 in.) radius at base of each tooth.

IMPORTANT

If a power grinder is used, DO NOT allow blade to over heat.

4.Lubricate blades. See "Lubrication".

5.Connect spark plug wire.

6 mm

(.25 in.)45° Radius