Echo PB-220SI 7

2 EMISSION ADJUSTMENT GUIDE

2-1 General adjusting rules

Before starting the unit for adjustment, check the following items.

1.The correct spark plug must be clean and properly gapped.

2.The air filter element must be clean and properly installed.

3.The muffler exhaust port must be clear of carbon.

4.The fuel lines, tank vent and fuel filter are in good condition and clear of debris.

5.The fuel is fresh ( > 89 octane : RON) and properly mixed at 50 : 1 with “ISO L-EGD” 2 stroke oil.

6.All blower pipes are installed for proper engine loading.

2-2 Presetting idle adjust screw, L mixture needle and H mixture needle

1. Turn L mixture needle clockwise until lean stop to cut easily.

2. Using a sharp knife, give triangle cut between the stopper wings. Also cut the H limiter cap.

NOTE : Be careful when cutting caps, otherwise injury may result.

3. Pull the caps off with pliers.

NOTE : Do not rock back and forth when removing, otherwise the needle may be damaged.

4. Turn H and L mixture needles clockwise until lightly seated.

NOTE : Do not over tighten needles, otherwise needles tip and seat damage may occur.

5. Turn L mixture needle anticlockwise 1 3/4 turns (PB-2100), 1 1/2turns (PB-2155, PB-2200SI). Turn H mixture needle anticlockwise 1 1/2 turns.

6. Turn idle adjust screw anticlockwise and set the screw until the tip to just contact throttle plate. Then turn it clockwise 1 1/2 turns.