ASSEMBLY |
ASSEMBLY
Drive Shaft/Power Head
Parts Required: | Power Head, Drive Shaft Assembly |
1.Stand power head upright on a level surface.
2.Loosen the drive shaft clamp bolt (A) at engine drive shaft clamp.
3.Remove dust cap and carefully fit drive shaft assembly to engine making sure that inner drive shaft engages into clutch mount.
Note: Gear Housing must be aligned properly with engine.
4.Tighten drive shaft clamp bolt (A) securely.
5.Route throttle linkage and ignition lead assembly below fan housing.
I A
Throttle Linkage and Ignition Leads
1.Close choke and remove air filter cover.
2.Place inner throttle cable in large hole of carburetor swivel
(A).
3.Loosen nuts (B) and place threaded end of throttle linkage in bracket slot. Finger tighten nuts (B).
4.Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. If adjustment cannot be achieved with adjusting nuts (B), consult with your Echo Dealer for correct adjustment procedure. Tighten nuts (B).
5.Connect 2 ignition stop leads (C,D) from throttle cable tubing to 2 ignition leads (C,D) on engine.
X7502310607
© 02/2014 ECHO Inc.
A
B
C
D
13