Power PrunerTM | 9 |
Operator's Manual |
9 8
7
10
6
11
5
4
12
3 2
1
13
1.POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Starter.
2.REAR HANDLE ASSEMBLY - Rear (right hand) handle.
3.THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttle trigger is prevented unless throttle trigger lockout lever is engaged.
4.STOP SWITCH - Mounted on top of rear handle assembly. Move switch forward to run, back to stop.
5.STRAP HOOK - Used to secure unit to shoulder harness.
6.FRONT HANDLE - Cushioned grip for left hand.
7.CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.
8.AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.
9.GUIDE BAR - 305 mm (12 in.) guide bar.
10.SAW CHAIN - 90, 9.53mm (3/8 inch) pitch, 0.043 gauge low profile saw chain. Runs approximately 609.6 m/min.
(2000 ft/min) at full throttle.
11.CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, acceler- ate and lower saw chain into branch.
