Echo PPT-265H manual Power PrunerTM Operators Manual

Power PrunerTM 11

Operator's Manual

1.POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Starter.

2.THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration press trigger gradu- ally for best operating technique.

3.SHOULDER HARNESS - An adjustable strap that suspends the unit from the operator.

4.CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.

5.CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, acceler-

ate and lower saw chain into branch.

6.GUIDE BAR - 305 mm (12 in.) guide bar w/chain tensioner.

7.SAW CHAIN - 91, 9.53 mm (3/8 in.) pitch, 0.050 gauge low profile Oregon® saw chain. Runs approximately

609.6 m/min. (2000 ft/min) at full throttle.

8.AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.

9.LOWER SHAFT TUBE - Durable fiberglass mesh housing.

10.STOP SWITCH - Mounted on top of handle assembly. Move switch forward to run, back to stop.

11.THROTTLE TRIGGER LOCKOUT - This lever must be depressed before throttle trigger can be operated.

12.REAR HANDLE ASSEMBLY - Sturdy handle for right hand placement. Includes stop switch and throttle trigger.

13.TOP GUARD - Protects arm from hot engine.

14.RECOIL STARTER - Pull recoil handle slowly until starter engages, then quickly and firmly. When engine starts return handle slowly. DO NOT let handle snap back or damage will occur.

15.SPARK ARRESTOR - CATALYTIC MUFFLER / MUFFLER -The muffler or catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of carbon from leaving the muffler. Keep exhaust area clear of flammable debris.

16.FUEL TANK - Contains fuel and fuel filter.

17.FUEL TANK CAP - Covers and seals fuel tank opening.

18.CHOKE - Located above air cleaner housing. Move lever to starting position () (close choke) and back to run position () (open choke).

19.AIR CLEANER ASSEMBLY - Contains replaceable air filter element.

20.PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging air from the carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump purge bulb an additional 4 or 5 times.

21.SPARK PLUG - Provides spark to ignite fuel mixture.

22.GUIDE BAR COVER - Used to cover guide bar and saw chain during transport and storage. Remove guide bar cover before using unit.