Echo SRM-210 OPERATOR'S MANUAL 27

GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 27

Level 1.

Parts Required: ECHO 0.095" Nylon Trimmer Line 6 m (20 ft.) long.

1. Shut engine off. Lay unit on the ground with head assembly up.

2. Hold drum (A) and turn spool (B) CW (clockwise) until it stops.

Pull spool from drum. DO NOT push in on spool when turning.

3. Use one piece of new nylon line (C) 6 m (20 ft.) long and thread

through the molded loop (D) on the spool. Pull line tight and

adjust so one end is 15 cm (6 in.) longer than the other.

4. Hold the spool, opening toward you. Place index finger between

the two strands and wind line, tightly and evenly, in direction of

arrow (E) marked "CC".

5. Stop when approximately 15-20 cm (6-8 in.) line (C) remains and

place ends of line in notches (F) in spool (B).

6. Feed ends of line through housing eyelets (G) and place spool (B)

over drive (H). Align pegs (I) on drive with notches in spool, and

push spool into drum.

7. Pull on both lines until they come free from notches (F) in spool.