Echo SRM-2100, 2110 OPERATOR'S MANUAL 21 O

GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 21

OPERATION

WARNING DANGER

The cutting attachment should not move at idle. If cutting attach-

ment moves, readjust carburetor according to "Carburetor Adjust-

ment" instructions in this manual or see your ECHO Dealer,

otherwise serious personal injury may result.

1 . Stop Switch - Start/Run.

Move stop switch button (A) forward away from the STOP

position.

2. Choke - Cold Start.

Move choke (B) to “Cold Start” Position.

3. Primer Bulb -Purge.

Pump primer bulb (C) until fuel is visible and flows freely in the

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

WARNING DANGER

Inspect starting area for hazards such as rocks, glass, debris etc.

which could be contacted by the cutting attachment when starting.

Keep helpers and bystanders at least 15 m (50 ft.) from starting

area, otherwise serious personal injury may result.

4. Lay the uniton a flat clear area. Firmly grasp right hand grip and

throttle trigger lockout with left hand and fully depress throttle

trigger to wide open position. Rapidly pull recoil starter handle/

rope (D) until engine fires (or maximum five [5] pulls).

5. After engine fires (or five [5] pulls), move choke lever back to

“Run” position. Hold throttle trigger and throttle trigger lockout

fully depressed and pull recoil starter handle/rope until engine

starts and runs. Release throttle trigger and allow unit to warm up

at idle for several minutes.

NOTE

If engine does not start with choke in “Run” position after 5 pulls,

repeat instructions.

6. After engine warm up, gradually depress throttle trigger to increase

engine RPM to operating speed.