24

lubrication

Level 1.

Tools Required: 13mm Open End Wrench, T27 Torx L-Wrench,

Clean Rag, Grease Gun

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or

Lithium Base Grease.

Gear Housing

1.

Clean all loose debris from gear box.

 

2.

Remove plug (A) and check level of grease.

A A

3.Add grease if necessary. DO NOT over-fill.

Drive Shaft

1.Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive shaft housing.

C

2. Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.

4.Install the gear housing and shield assembly.

IMPORTANT

D

Flat edge of washers (D) must be against drive shaft.

B

B