Grass Trimmer/Brush Cutter | 9 |
Operator's Manual |
Contents
The ECHO product you purchased has been partially assembled for your convenience. Due to packaging restrictions, installation of the plastic debris shield, nylon line head, and positioning of the front handle are necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.
*Some Echo units may be factory
_______1 - | Power Head / Drive Shaft Assembly | |
______ | - | 1, Operator's Manual |
______ | - | 1, Safety Manual |
______ | - | 1, Warranty Registration Card |
_______ | - | 1, Safety Glasses |
_______ | - | 1, Echo Power BlendX TM |
*_ _____ | - | 1, Nylon Trimmer Head |
*_ _____ | - | 1, |
*_ _____ | - | 1, Torx T27 |
*_ _____ | - | 1, locking tool |
*_ _____ |
| |
*_ _____ |
| |
*_ _____ |
|
Grass Trimmer/Brush Cutter
Operator's Manual
MODELS
WARNING
Read rules for safe operation and instructions carefully. ECHO provides an Operator's Manual and a Safety Manual. Both must be read and understood for proper and safe operation. Failure to do so could result in serous injury.
X7722271100 | X772000120 |
| 07/08 |
Assembly
plastic shield installation
(for Nylon Line Operation)
Tools Required: Torx T27
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm screws.
NOTE
The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic or metal blades.
1.Remove plastic threaded shaft sleeve and adapter plate (C) from PTO shaft (A).
2.Place the shield on the bottom of the bearing housing flange.
3.Place shield plate (B) on shield, align holes. Install three (3) screws from bottom through plate and shield into gear case.
4.Assemble adapter plate (C) onto PTO shaft.
A
B C