Echo SRM-230 LUBRICATION

GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 23

NOTE

Every unit is run at the factory and the carburetor is set in compli-

ance with Emission Regulations. This carburetor does not have

acceleration and high speed adjustment needles.

1. Check idle speed and reset if necessary. If a tachometer is available,

idle speed screw (A) should be set to the specifications found on

page 10 "Specifications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease idle

speed.

WARNING DANGER

When carburetor adjustment is completed, the cutting attachment

should not move at idle, otherwise serious personal injury may

result.

LUBRICATION

Level 1.

Tools Required: 8 mm Open End Wrench, Screwdriver, Clean Rag.

Parts Required: ECHO® LUBETM 8 oz. (P/N 91014) or Lithium Base

Grease.

1. Clean all loose debris from gear box.

2. Remove plug (A) and check level of grease.

3. Add grease if necessary, DO NOT over fill.

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of ECHO® LUBETM

grease.

3. Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.