Echo SRM - 260S, SRM-260

GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 25

1. Check idle speed and reset if necessary. If a tachometer is avail-

able, idle speed screw (A) should be set to the specifications found

on page 10 "Specifications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease idle

speed.

WARNING DANGER

When carburetor adjustment is completed, the cutting attachment

should not turn at idle, otherwise serious personal injury may

result.

LUBRICATION

Level 1.

Tools Required: 8 mm Open End Wrench, Screwdriver, Clean Rag.

Parts Required: ECHO® LUBETM 8 oz. (P/N 91014) or Lithium Base

Grease.

Gear Housing

1. Clean all loose debris from gear box.

2. Remove plug (A) and check level of grease.

3. Add grease if necessary. DO NOT over-fill.

Drive Shaft

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.