24

lubrication

Level 1.

Tools Required: 8 & 13mm Open End Wrench, Screwdriver, Clean

Rag, Grease Gun

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium

Base Grease.

Gear Housing

1. Clean all loose debris from gear box.

A

A

 

 

2.Remove plug (A) and check level of grease.

3.Add grease if necessary. DO NOT over-fill.

Drive Shaft

(SRM-265 Only)

1. Loosen two (2) screws (B) and remove center locating screw (C).

C

 

Pull gear box and shield from drive shaft housing.

 

2.Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.

4. Install the gear housing and shield assembly.

D

 

 

 

 

 

IMPORTANT

 

 

Flat edge of washers (D) must be against drive shaft.

 

 

 

 

B

B

(SRM-265S Only)

No Lubrication Needed.