OPERATION | |
|
|
To Advance Trimmer Line
See Maintenance Section for nylon line replacement.
Note: To advance trimmer line, tap trimmer head against the ground while the head is turning at normal operating speed.
Remove Nylon Line Head
Note: Do not disassemble nylon line head.
1.Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (D).
2.Remove line head (E) by turning it clockwise until head is completely off of shaft.
3.Remove locking tool (D).
Support Handle Installation
Note: Label shows minimum spacing for support handle location.
1.If necessary, position support handle for comfortable operation and securely tighten screws.
OPERATION
D
E
MIN
SPACING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause unconsciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is directed away from your face and body.
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor to prevent discharge of hot particles from the engine. Metal cutters can also create sparks if the cutter strikes rocks, metal, or other hard objects. Contact local fire authorities for laws or regulations regarding fire prevention requirements.
X7502026104 | 15 |
© 9/2014 ECHO Inc.