ASSEMBLING

Bolts

Right hand grip assembly

Slot

Right hand U-handle

Grip assembling bolt

Handle assembling bolt (8 mm)

Bolt retainer tube

Handle assembling bracket (upper)

Handle assembling bolt (8 mm)

Left handle

DRIVE SHAFT

•Stand engine upright on a level floor.

•Loosen bolts at drive shaft end of the engine.

•Fit drive shaft assembly ensuring that the drive shaft is correctly engaged.

•Tighten bolts to fasten drive shaft assembly.

WARNING DANGER

NEVER START ENGINE WITHOUT DRIVESHAFT ASSEMBLY INSTALLED. THIS COULD RESULT IN SERIOUS INJURY.

HANDLE

Insert right hand grip assembly into right hand U- handle and fit it to the slot for rotation prevention of right hand U-handle.

Fit grip assembling bolt and secure the grip firmly.

Remove bolt retainer tube from end of handle assembling bolt (8 mm).

Install handle assembling bracket (upper) in handle assembling bracket (lower) and fix handle by tightening handle assembling bolt (8 mm) lightly.

Handle assembling bracket (lower)

To engine

5