4.2 Special conditions for use in areas of Zone 0 or 21
1.The
2.The torch unit should be prevented from being dropped.
3.The torch unit must not be left any- where or stored in Zones 0 or 21.
4.3 Special conditions in dusty Ex-areas
1.After each change of batteries, the torch must be blown out or internally cleaned with a suitable device.
2.The sealing ring must be checked for any deterioration or damage.
5. Ex-Data
EC Certificate of Conformity No.:
ZELM 02 ATEX 0104
II 1 G EEx ia IIC T4
II 2 D T90°C IP 52
Approved for Zone 2, 1and 0; equipment group II, gas group IIC;
explosive gases, vapours or fog, temperature class T4.
Approved for Zone 22 and 21; equipment group II, explosive dusts; T90°C
Report Job Identification No.: 3015562
I.S. Class I Division 1 Group
6. Technical Data
Ambient operating |
|
temperature Ta: | |
Storage temperature: | |
Batteries / power supply: | 3 x LR1 as per IEC |
(see table of approved battery types)
Table of approved batter y types
Manufacturer | Type |
|
Duracell | Alkaline MN9100 |
|
Varta | Electronics 4001 |
|
Eveready Battery |
|
|
Company, Inc. | Energizer E90 |
|
Battery life: | approx. 80 h (continuous use) | |
Dimensions: | 140 x 26 mm (l x ø) | |
Weight: | approx. 160g (with batteries) | |
0102 |
| |
Light source: |
|
|
Type: | ||
| (NSPW500BS) | |
Life expectancy: | 100.000 operating hours |
7.Use and Application / Operating Instructions
Before use, please read these operating instructions very carefully in order to familiarise yourself with your
For you own safety and information, please read the following instructions.
7.1 Commissioning
In order to be able to use the torch in the
7.2 Battery Replacement
When the brightness is no longer satis- factory and the batteries are to be replaced, it is strongly recommended that all 3 batteries should be replaced as a set. When replacing the batteries
16 | 17 |