8.4 Cleaning the twist ring
A
8.5 Lamp replacement
The
8.6 Replacing the spare disc
The torch head is protected by the housing head that surrounds it as well as an additional disc, which is positioned over the opening where the beam is emitted. The disc is made of
the twist ring, and carefully unscrew the housing head by turning it anticlockwise. Clean the housing head thoroughly to remove any remaining pieces, and check the sealing ring for damage. After this has been done, you can install a new glass disc and, if necessary, new sealing rings. Only spare sealing rings of ecom instruments are allowed. The sealing ring is positioned between the housing head and the disc (see illustration 1). When putting the housing head back on, ensure that the seal is positioned properly on the disc. After installation, you should not be able to see any part of the sealing ring through the opening where the beam is emitted. If the inside of the torch head or lens is also damaged, the torch should be sent to the manufac- turer for repair.
9. Repairs
Repair work is subject to the nationally valid regulations and directives. We therefore recommend that such work be performed by ecom instruments GmbH, Germany, as all repairs must be examined to ensure functional safety.
16