Edelbrock High Flow 8” Air Cleaner Element for
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before installing your new
EFI engines. If you have any questions or problems, do not hesitate to contact our Technical Hotline at:
5pm,
•Description:
This Edelbrock
•Kit Contents:
Qty. Description
1 Air Cleaner Element
3Set Screws (Allen Head)
31/4” I.D. x 1/2” Spacers
31/4” Washers
31/4” Nylon Lock Nuts
Note: The | Edelbrock High- |
|
|
Flow Air Cleaner is 1/2” taller | Stock | Edelbrock | |
than stock. | The taper is |
|
|
reversed, which will require the |
|
|
use of an 8” air cleaner cover.
2.Slip the 1/2” spacers over the set screws.
1.Install the 3 supplied set screws into the original air cleaner bolt holes using a 1/8” Allen wrench. Apply a small amount of blue Loctite to the threads before installation.
3.Place the air cleaner element over the set screws and secure the air cleaner with the supplied washers and nylon locknuts.
4.Install your air cleaner cover. An 8” diameter cover must be used. Notice that there are four additional holes in the air cleaner plate. These are to allow use of the filter on early OEM Harley (Magneti Marelli) fuel injection. These will be sealed when the air cleaner cover is installed. Therefore, unfiltered air will not be allowed into the engine.
The words Twin Cam, Harley, and
reference only.
Edelbrock is a registered trademark of Edelbrock Corporation 2700 California St., Torrance, CA 90503, USA
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: (800) 416-8628
Office: (310)
E-Mail: Edelbrock@Edelbrock.com
Brochure # | Catalog # 8679 |
©2004 Edelbrock Corporation | Rev. 6/04 - RS/mc |