USB PORT TO SERIAL PORT ADAPTER CABLE
®For Use with Edelbrock QwikData or EFI Systems, As Well As Other Data Acquisition or EFI Systems Catalog #91147
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. If you have any questions, please call our Technical Hotline at:
DESCRIPTION: This is a USB to Serial communications adapter cable. It is used to convert a Laptop or PC USB port to a
KIT CONTENTS
❑1
SYSTEM REQUIREMENTS
Hardware – A
Software – Microsoft® Windows 98SE/ME/2000/XP
INSTALLATION: The drivers for the
Microsoft® Windows Installation
Insert the disc into your
NOTE: You may use the same program to
TROUBLESHOOTING: If the adapter is not communicating after installation of the driver, follow the troubleshooting suggestions below.
•Many serial devices will not operate on a COM port higher than 4. If the COM port is higher than 4, change it to a lower number using the Device Properties.
•To change the assigned COM number, go to the Start menu, click Control Panel then System. Select the Hardware tab and then Device Manager. Select the category “Ports (COM & LPT)” and right click the device
NOTE: This procedure applies only to Windows 98SE, ME, 2000, and XP.
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com
Catalog #91147 | ©2008 Edelbrock Corporation |
Rev. 4/08 - AJ/mc | Brochure |