7
1. The boost sensor is
located on the
driver’s side of the
engine as shown in
the photo.
Disconnect the
stock connector and
plug in the supplied
connectors that are
located closest to
the Power Edge EZ
CAT module.
2. The IAP sensor is located on the driver’s side towards the front of the engine.
Disconnect the stock connector and plug in the connectors located at the end of
the EZ CAT harness (furthest from the module).
3. The EZ CAT Module can mount on or near the firewall. Adhere the module
using the supplied velcro.
4. Recheck all connections, fittings and fasteners for a properly secure
installation.
5. Using the supplied wire ties, secure the wiring harness from possible damage.
The installation of the brass elbow permits the turbo boost pressure to increase
without the wastegate opening. The Power Edge EZ CAT Module will operate
equally well with or without this installed.
6. Using the pliers, remove the crimp style clamp from the hose on the stock brass
elbow located on the bottom side of the turbocharger. Remove the hose from
the brass elbow and dispose of the crimp style clamp.
Boost Senso
r