EdgeStar CWR460DZ owner manual Installing the Door Handle, Installing and Removing the Shelves

Installing the Door Handle

To install the door handle:

1.Open the door and carefully pull the door gasket around the area where the handle is to be installed.

2.Carefully remove the two pre-installed decorative plugs from the front of the door. Note: some wine coolers do not have decorative plugs installed.

3.Insert each Phillips head screw through the gasket side of the door until the screw pass through the door.

4.Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush against the door frame.

CAUTION: Do not over-tighten the screws as this may cause damage to the handle or to the stainless steel door

5.Carefully press the door gasket into its original position.

Installing and Removing the Shelves

To prevent damaging the door gasket, make sure to open the door all the way before pulling the shelves out of their track.

To install the shelves:

1.Open the door completely.

2.Slide the shelf on the shelf track and slowly push back until it stops.

3.Push down on the front of the shelf to allow the back of the shelf to lift over the plastic post. (Imagine a seesaw movement.) Continue to push the shelf back until both notches pass through the plastic posts on each side of the shelf track.

4.Continue to push the shelf back.

To remove the shelves:

1.Open the door completely.

2.If necessary, make sure you remove all the contents sitting on the shelf.

3.Pull the shelf forward until the notch aligns with the plastic post on each side of the shelf track.

4.Lift the shelf until both notches pass through the posts.

5.Continue to pull the shelf forward until it is completely removed from the inner compartment.

EdgeStar Wine Refrigerator 6