EdgeStar TWR210EBL specifications Welcome and Thank You, Table of Contents

Table of Contents

Table of Contents		1
Welcome Message and Thank You		1
Important Safeguards		2
1.	Specifications	3
2.	Parts and Features	4
3.	Operation	4
4.	Troubleshooting	7
5.	Limited Warranty	9

Welcome and Thank You

Welcome and thank you for purchasing this EdgeStar® wine cooler. Once you complete our easy unit set up by following this manual, it will provide you and your family years of great service.

If you are reading this owner’s manual, you’ve probably already unpacked the unit. Note that you should save the packaging in case you need to safely transport this wine cooler in the future.

In order to assemble this wine cooler, carefully unpack all parts. The only assembly required is that of the handle(s). In order to install a handle, you need a Phillips head screwdriver, the handle(s), and the two installation screws.

•Open the door of the wine cooler.

•Locate the two screw holes on the inside of the door (they may be partially obscured by the door liner gasket.

•Insert the screws into the holes. They should now poke out of the front of the door.

•Line up the holes in the handle with the screws and give each screw about 2-4 full turns into the handle.

•Now screw the screws in all the way, and your handle is installed!

After you get the handle(s) installed, make sure that your wine cooler is fully unpacked, and position it into your preferred location (remember, for the best conditions for your wine, choose a spot in a cool (room temperature) area, away from direct sunlight leaving about 2-4 inches around all sides, specifically the back for adequate ventilation. Make sure the unit is set on a sturdy surface that can support its weight.

Note: that you can screw in and out the legs to level the unit. You may also want to clean the interior with a solution of mild soap and water and a damp cloth. Then plug the unit in, set the temperature, and fill it with wine.

1