6. The quick installation program will not only set
up the PrintSir, but create and setup all required
objects on the file server. When the setup is
complete, it will also display an execution
command as following that you can run after
logging in to the file server to redirect print
commands to the new PrintSir. :
capture /S=III /Q=PRINTSIR_Q1 /nt /nff /nb /l=1 /ti=10
This redirects the LPT1 port (/l=1) to the print
queue PRINTSIR_Q1 on the file server named III.
No banner page will be printed (/nb), no form
feed will be added to the end of the job (/nff),
and tabs will not be expanded into spaces (/nt).
If the program does not explicitly signal end-of-
job, the capture facility will wait 10 seconds
(/ti=10) before assuming that the print job is
complete.
7. Reset the PrintSir to have the changes take effect.
Before printing, you may want to verify that the setup
was complete. Using the PrintSir Status option of the
PSETUP command (as described in the following section),
you can verify that the PrintSir is connected to the right
49