Model Ei156TLH Optical
Technical Specification
SensorOptical, uses light scatter from
smoke
Sensitivity:Complies with BS 5446 Part 1: 2000
Source:Contains no radioactive material
Airspeed:Essentially immune to the effect of airspeed.
Button Test:Simulates the effect of smoke and checks chamber, electronics and horn.
Alarm: | Electronic Piezoelectric horn |
Alarm Sound Output: | 85dB (minimum) at 3m |
Alarm Status: | Red LED flashes every second on |
| unit sensing fire |
Temperature Range: | 0° to 40°C |
Humidity Range: | 15% to 95% Relative Humidity |
Interconnect: | Up to 12 interconnected |
| Ei150/151TLR/154TL/155/156TLH/ |
| 156TLR smoke or heat alarms, |
| along with an EI158 relay base |
Ambient Light: | Chamber housing design and |
|
|
| compensation overcomes | Fixing: | Screw fixings supplied |
| problems with stray light. |
|
|
|
| Plastic material: | UL94VO flame retardant |
Automatic | Smoke Chamber is tested every 40 |
|
|
| Sec. and unit beeps (without LED | Dimensions: | 140mm x 120mm x 46mm |
| flash) if it is degraded. |
|
|
|
| Weight: | 218g |
Insect Screen: | Prevents insects or debris entering |
|
|
| chamber (1.00mm mesh size) | Warranty: | 5 year (limited) warranty |
Supply Voltage: | 230V AC | Approvals: | Kitemarked to BS EN 14604:2005, |
|
|
| CE Approved |
Battery back up: | Rechargeable lithium cells |
|
|
|
| Specifications are subject to change | |
Continuous green LED |
|
| |
Installation & Placement |
| Important Precaution: | |
| Do not install the actual smoke/heat | ||
Wiring for Interconnected Alarms |
| alarm itself in new or renovated |
| buildings until all work is completed | |
| (including floor coverings) and the | |
| building has been fully cleaned. | |
| The wiring can be installed when | |
| appropriate. (Excessive dust and | |
| debris from building work can | |
| contaminate the smoke chamber | |
| and cause problems, and it will also | |
| invalidate the guarantee). If it must | |
| be installed, cover it completely, | |
Be very careful about correctly wiring the alarms as mixing Live and Neutral | particularly around the edges, with | |
a dust cover (eg. a plastic bag), | ||
will blow/damage interconnected alarms. | ||
until all cleaning is finished.. | ||
| ||
Alarms should be placed in accordance with the general guidelines shown in | Connect wires to the unit as in | |
wiring diagram. All wiring must | ||
the diagram above. These recommendations are based on the problem of | ||
comply with local codes. | ||
areas of “dead air” close to corners of rooms and apexes of ceilings, which | ||
| ||
could result in the prevention of smoke reaching the smoke detector |
| |
Please consult instruction booklet for specific installation details |
|
Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph.+353 61 471277 Fx.+353 61 471053
Email. eielectronics@eiltd.ie
Web: www.eielectronics.com
E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice. | Ei156TLH DataSht RevB |