Model Ei176 Optical
Technical Specification
Sensor | Optical, uses light scatter from |
| smoke |
Sensitivity: | Complies with BS 5446 Part 1: |
| 2000 |
Source: | Contains no radioactive material |
Airspeed: | Essentially immune to the effect |
| of airspeed. |
Ambient Light: | Chamber housing design and |
| compensation overcomes |
| problems with stray light |
Button Test: | Tests strobe, vibration pad and |
| panel |
Fault Monitor: | Open/short circuit |
Supply Voltage: | 230V AC standby 8mA, alarm |
| 40mA |
Battery back up: | Sealed Rechargeable lead acid |
| battery |
Auxiliary socket: | Provides 12V/200mA in alarm |
Continuous green LED | |
Alarm: | Xenon tube strobe (1Hz) |
Temperature Range: | 0 to 40°C |
Humidity Range: | 0% to 90% Relative Humidity |
Interconnect: | Up to 12 interconnected |
| Ei100C/105C/103C smoke/heat |
| alarms |
Fixing: | Screw fixings supplied |
Plastic material: | UL94VO flame retardant |
Warranty: | 5 year (limited) warranty |
Approvals: | BS 415:1990 electrical safety |
Specifications are subject to change
Placement Information
Alarms should be placed in accordance with the general guidelines shown in the diagram above. These recommendations are based on the problem of areas of “dead air” close to corners of rooms and apexes of ceilings, which could result in the prevention of smoke reaching the smoke detector
Important Precaution:
Do not install the actual smoke/heat alarm itself in new or renovated buildings until all work is completed (including floor coverings) and the building has been fully cleaned. The wiring can be installed when appropriate. (Excessive dust and debris from building work can contaminate the smoke chamber and cause problems, and it will also invalidate the guarantee). If it must be installed, cover it completely, particularly around the edges, with a dust cover (eg. a plastic bag), until all cleaning is finished.. Connect wires to the unit as in wiring diagram. All wiring must comply with local codes.
Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph.+353 61 471277 Fx.+353 61 471053
Email. eielectronics@eiltd.ie
Web: www.eielectronics.com
E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice. | Ei176 DataSht RevA |